The second prototype

So, I found out out with the previous prototype that too much pressure at the top of the belt (where the screw sits) causes bruises. Therefore I changed the belt and added a bigger ring like structure at the top, so that the pressure is evenly distributed.

I also wanted the penis cage to be a fully closed tube because with bars I feel it is less secure. 

I have a 3D printer at home, so I started and printed a tube. I did this by printing two halves and then cleaning, smoothing and finally gluing together the halves. Afterwards I added a layer of paint. 


This is what it looked like:



This worked out much better. The pressure was distributed over a bigger area, however I still felt that the area at the top could be bigger to be even more comfortable.


Comments

Post a Comment

Popular posts from this blog

Butt plug for the chastity belt prototype

Image
 Beside the chastity belt I also wanted to have a "lockable" buttplug. Meaning, that when caged there also would be the possibility to add a plug that could not be removed without unlocking. I thought about various methods how this could be archived. I came up with a solution that I think is quite nice. I printed the design with my 3d printer. It looked like this. Again this was printed in two halves, sanded, smoothed and painted. The form results in direct pressure being applied to the prostate. It is attached to the belt (when the belt is unlocked) by sliding it onto the steel cables in a 90 degrees angle and then turning it upside again. It can not be removed when the belt is worn because you can not pull out the plug because the steel cables are holding it inside you. You can not remove the plug from the steel cables because you can not rotate the plug 90 degrees without pulling it out... Simple but effective. The contraption looked like this after being assembled with th...
Read more

An additional optional (lockable) anal shield/opening

Image
So after a while looking at other belts I noticed that some of them featured an anal-opening in the cables. I always found those very erotic. Being "exposed" and "usable" while staying locked in the belt at all times is a huge turn-on for me.  True, the cables can be parted and e.g. a Dildo could be used for pegging, but I imagine for a real dick it would be painful to go between tight cables. So I designed an anal opening that goes together with my belt. This is what I came up with and what Dietmar produced (after some more 3d designing and printing etc.) I tried to design the opening absolutely ergonomic. Meaning that it is not a "flat" opening, but the "flaps" on the side have an additional bend away from the body following the curve of your butt-cheeks. This way I thought it would be more comfortable to wear and could be worn closer to the body. The opening itself is nearly 5cm in diameter, so I imagine it is enough space for any dick or toy ...
Read more

The vac-u-lock adapter

Image
Meanwhile Dietmar finished the vac-u-lock adapter! The adapter can be removed and exchanged for anything else that can be screwed onto the dildo-holder.  This gives some extra flexibility and you don't even have to use vac-u-lock dildos. You could simply make any attachment you like!
Read more